Publicidad
Idiomas disponibles
Idiomas disponibles
Temperature setting
A
ON/OFF switch, turn on by pressing once, turn off by pressing and holding 5 seconds.
B
Decrease temperature of 1 degree Celsius or Fahrenheit.
C
Raise temperature of 1 degree Celsius or Fahrenheit.
Display shows upper zone temperature at its setting.
D
E
Temperature display in Celsius or Fahrenheit
Compartment selecting switch (lower or upper one). Once the compartment has been
selected, it will show setting temperature as flash, 5 seconds later flash will stop and setting
H
temperature will be showing
J
Light ON/OFF switch, turn on and turn off the light.
H + J
Press both H and J to switch degree Celsius or Fahrenheit
Temperature selection
The appliance designed as 5~20C, 5~12 is ideal for storing sparking and white wines; while once it adjusted
to 12~20C, it was the ideally storing for white and red wine.
When the unit is plugged in for the first time, the display will show the original temperature set previously.
To select the temperature, press H once, display D will flash, you could touch key C to increase or key B to
decrease the temperature. The degrees indicators will appear in the display window. Attention that setting
temperature could only be set under display flash status.
Temperature display
Display show at its setting.
To view the actual temperature at any time, press buttons B and C on the control panel for 3 seconds. The
actual temperature will flash temporarily on the display. Then the set temperature will be displayed when
you stop pressing both buttons.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature setting on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to wait
5 minutes before turning it on again.
Temperature alarm
Your appliance is equipped with a visual and audible temperature alarm. If the error codes HH and LL
appear on the control panel display, check that you are not in the following situations:
44
Publicidad
