REVAMP Professional PROGLOSS HYDRO SHIELD X SHINE Guia Del Usuario página 2

FEATURES
1
1. Floating 11cm ceramic plates
2. Digital temperature display
3. Temperature controls
4. Hydro Shield sensor button
HYDRO SHIELD SENSOR
When turned on, the sensor will measure and regulate the power output of the super
smooth deep floating plates to minimize over-exposure to heat when styling.
POSITIVE AND NEGATIVE IONIC JETS
The Progloss Hydro Shield X Shine includes four powerful ionic emitters: two positive and
two negative, for salon shine & frizz-free finish.
NOTE: If you hear a faint buzz when using the straightener please do not be concerned,
this is the ionic pins working to ensure the ions are fully released onto your hair for
smoother, frizz free styling.
PROGLOSS™ SUPER SMOOTH OILS
Every product in the Revamp haircare range is infused with PROGLOSS™ SUPER SMOOTH
OILS - enriched with Argan, Keratin and Coconut for ultimate smoothness and shine.
INSTRUCTIONS FOR USE
• Before use, ensure the hair is clean, dry and tangle-free.
• For extra protection, apply a heat protection spray.
• Section the hair prior to styling. Style the lower layers first.
• Plug the product into a 220-240V mains power supply.
• Press and hold down the power
straightener
• Use the sensor button to turn the sensor on and off.
• Use the temperature control buttons + - to select your desired temperature (80°C -
235°C). We recommend using a lower temperature to start.
• To use the hair type modes long press the + button and the hair mode will appear on
screen, to change this press the + button again. To turn off the hair mode long press
the + button again.
• The temperature lock will activate automatically after a few seconds - a lock symbol
will appear on the temperature display. To switch off the temperature lock to adjust
the heat or sensor, press the power
• Working on one section at a time run the straightener through the entire length of
the hair from roots to ends, without stopping. Use a comb while straightening for even
straighter results.
• Repeat this process all over the head, allowing hair to cool before combing through.
• After using the straighteners, switch off by holding the POWER button
seconds, unplug, place on your REVAMP heat resistant mat and allow to cool before
storing away.
2
7
6
5. Power button
6. Ion emitters
7. Hydro Shield sensor
8. Plate lock
9. Heat proof silicone mat
button for 3 seconds to switch on (and off) the
button once.
8
4 5
3
9
for 3