Kingfisher Hollis ST1008WU Instrucciones página 3

EN Safety
EN Safety
• These instructions are for your safety.
Please read through them thoroughly
prior to installation and retain them for
future reference.
• All fittings must be installed by a competent
person in accordance with local regulations
(IET wiring regulation BS7671).
• Check the pack and make sure you have all
of the parts listed.
• Remove all packaging, wrap etc.
from the product.
• Decide on the appropriate location for
your product.
CAUTION: IP44 is guaranteed when
the product is properly installed and
sealed.
• Always avoid the product to be located at
corrosive environment.
• Always refer to the installation drawing for
the orientation of the product.
• The product must be securely fixed to the
mounting surface using the screws and
wall plugs supplied. The screws and wall
plugs supplied are suitable for "masonry"
only. Other fixings not supplied and must
be purchased.
• Take care not to drill into any pipes or
mains cables beneath the surface during
mounting holes preparation.
IMPORTANT: The fixing point(s)
selected must be capable of supporting
the full weight of the light fitting.
• Wiring diagram is for reference only.
Always refer to the terminal marking
for wiring. Ensure that all electrical
connections are tight and that no loose
strands are left out of the terminal block.
• Never put anything on the product or hang
anything on any part of this product.
216583_s8_s3-5059340247427-No Name-A5-IM-V03.indb 2 216583_s8_s3-5059340247427-No Name-A5-IM-V03.indb 2
• Never use the terminal cables to bear
the product weight.
• When the product does not light after
installation:
> Ensure there is no electricity failure.
> Ensure all the connections are secured.
• If you have any doubt about installation /
use of this product, consult a qualified
electrician.
• Always disconnect the product from mains
at least 10 minutes allowing to cool down
before any maintenance or adjustment.
• It is recommended to have a regular
schedule of care and maintenance to
keep the surface condition well.
02
29-09-2021 11:19:38 29-09-2021 11:19:38