Samsung DV45H7200E Serie Manual De Instrucciones página 30

troubleshooting
probleM
Shuts off before load is dry
lint on clothes
Garments still wrinkled after
Wrinkle release
odors remain in clothing
after air fluff.
InformatIon coDES
Information codes may be displayed to help you understand what is occurring with your Dryer better.
error display
te
he
de
Fe
9e1
ae
e3
dF
be
(dV45h7000e(g)*)
be2
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG).
DV7000HA DRY_DV48H_USER MANUAL_DC68-03170J-08_EN.indd 30
solution
• The dryer load is too small. Add more items or a few towels and
restart the cycle.
• The dryer load is too large. Remove some items and restart the dryer.
• Make sure the lint filter is cleaned before every load. With some loads
that produce high amounts of lint, it may be necessary to clean the
filter during the cycle.
• Some fabrics are lint producers (for example, a fuzzy white cotton
towel) and they should be dried separately from clothes that are lint
trappers (for example, a pair of black linen pants).
• Divide larger loads into smaller loads for drying.
• Check pockets thoroughly before washing and drying clothes.
• Small loads of 1 to 4 items work best.
• Load fewer garments. Load similar-type garments.
• Fabrics containing strong odors should be washed in a normal cycle.
Meaning
Temperature sensor problem.
Invalid heating Temp in running the
dryer).
Running the dryer with door open.
Invalid power source Frequency.
Electronic Control Problem
(Over Voltage Error).
Electronic Control Problem
(Communication Error).
Invalid state of Eeprom
Communication.
Invalid door.
Unit detects a button is being
pressed for over 30secs or button is
stuck.
English - 30
solution
Restart the cycle.
If the code reappears, call for service.
Call for service.
Close the door and then restart.
If the problem continues, call for service.
Try restarting the cycle.
If the problem continues, call for service.
Call for service.
Call for service.
Call for service.
Call for service.
Make sure a button is NOT being pressed
continuously. Try restarting the cycle.
If the problem continues, call for service.
2016/2/25 16:21:09