Publicidad
Idiomas disponibles
Idiomas disponibles
protection must b eused forappropriate
conditions.
TOOL USE AND CARE
• Use clamps or other practical way to
secure and support the workpiece to a
stable platform. Holding the work by
hand or against your body is unstable
and may lead to toss of control.
• Do not force tool. Use the correct
tool
for your application.
The correct tool
will do the job better and safer at the rate
for which it is designed.
• Do not use tool if switch does not turn
it on or off. Any toot that cannot be
controlled with the switch is dangerous
and must be repaired.
• Disconnect
the plug from the power
source before making any
adjustments,
changing
accessories,
or storing the tool. Such preventative
safety measures reduce the risk of
starting the toot accidentally.
• Store idle tools out of reach of
children
and other untrained
persons.
Tools are dangerous in the hands of
untrained users.
• Maintain tools with care. Keep cutting
tools sharp and clean. Properly
maintained tools, with sharp cutting
edges are less likely to bind and are
easier to control.
• Check for misalignment
or binding
of
moving parts, breakage
of parts, and
any other condition
that may affect the
tools operation.
If damaged,
have the
tool serviced before using. Many
accidents are caused by poorly
maintained tools.
• Use only accessories
that are
recommended
by the manufacturer
for
your model. Accessories that may be
suitable for one tool, may become
hazardous when used on another toot.
SERVICE
• Tool service must be performed only
by qualified repair personnel. Service
or maintenance performed by unqualified
personnel could result in a risk of injury•
• When servicing a tool, use only
identical
replacement
parts. Follow
instructions
in the Maintenance
section of this manual. Use of
unauthorized parts or failure to follow
Maintenance Instructions may create a
risk of electric shock or injury.
• The label on your toot may include the
following symbols.
V .............. volts
A .............. amperes
Hz ............ hertz
W ............ watts
min .......... minutes
'_ ............ alternating current
............
direct current
no ............ no load speed
[] ............ Class II Construction
•../min ...... revolutions or reciprocation
per minute
@ ............ earthing terminal
Jt, ............ safety alert symbol
• ALWAYS WEAR EYE PROTECTION.
• Clean your toot out periodically.
_kCAUTION: Wear appropriate hearing
protection during use. Under some
conditions and duration of use, noise from
this product may contribute to hearing loss.
• Hold tool by insulated
gripping
surfaces
when performing
an
operation
where the cutting
tool may
contact
hidden wiring or its own cord.
Contact with a "live" wire will make
exposed metal parts of the toot "live" and
shock the operator.
_, WARNING: Some dust created by
power sanding,
sawing, grinding,
drilling,
and other construction
activities
contains
chemicals
known to
cause cancer, birth defects
or other
reproductive
harm. Some examples
of
these chemicals
are:
• lead from lead-based paints,
• crystalline silica from bricks and cement
and other masonry products, and
• arsenic and chromium from chemically-
treated lumber. (CCA)
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals:work
in a well ventilated area,
and work with approved safety equipment,
such as those dust masks that are
specially designed to filter out microscopic
particles.
• Avoid prolonged contact with dust
from power sanding, sawing, grinding,
drilling, and other construction
activities. Wear protective clothing
and wash exposed areas with soap
and water. Allowing dust to get into your
mouth, eyes, or lay on the skin may
jipromote
absorption of harmful chemicals•
WARNING:
Use of this tool can
generate
and/or disburse
dust, which
Publicidad
