Publicidad
Idiomas disponibles
Idiomas disponibles
Registering a key detector to the unit
Important:
R For key detector supplied users: The supplied key detector has been
pre-registered to the unit.
R Do not install the battery until you activate the key detector registration using the
handset.
R After installing the battery in step 2, the registration mode will end within 30
seconds.
1
Handset:
For key detector 1: MMENUN#6571
For key detector 2: MMENUN#6572
For key detector 3: MMENUN#6573
For key detector 4: MMENUN#6574
*1
2
Key detector:
With the tab pushed to the right (A), pull out the battery holder (B). Insert the
battery with (
R Confirm that the battery is set correctly (
R The key detector will go into the registration mode automatically and the
3
Wait until a long beep sounds.
R After the key detector is registered, the detector number is displayed.
4
Handset: MOFFN
If the registration tones do not sound or the registration fails, you need to remove
the battery from the key detector once to make the key detector available for
registration again. Leave the battery out of the key detector for over 2 minutes,
and then repeat from step 1.
TGA20(en-en)_1201_ver022.pdf
If you have 2 or more key detectors.
) facing up (C), then close the battery holder (D).
registration tones will sound.
B
A
3
Installation
*1
*1
*1
,
).
C
D
2012/12/01
3
19:54:54
Publicidad
