JCB -18CS Instrucciones De Funcionamiento página 17

Circular Saw Assembly
WARNING!
Prior to any assembly and adjustment always
disconnect the tool from the power supply.
Place this circular saw on its side on a flat
m
surface. Bring the base plate down to the
minimum depth cut as it's easier to change
the blade.
Press the spindle lock and carefully turn the
m
blade until the spindle lock engages.
Unscrew the blade screw with a spanner.
m
Remove the blade screw, any washers and
m
blade flange.
Loosen the lower guard lock lever, move
m
the bottom cover to one side.
Change to an appropriate blade. Fit the
m
blade with the direction marking on the
blade in the same direction as the direction
indicator.
Refit the blade flange, any washers and the
m
blade screw.
Press in the spindle lock and tighten the
m
blade screw with a spanner.
Depth Adjustment
Loosen the depth adjustment lock knob.
m
Adjust the bottom plate to the required
m
depth according to the depth scale, or
measure with a ruler.
Tighten the lock knob.
m
Angle Adjustment
Loosen the Lock knob for angle adjustment.
m
16
Adjust the shoe to the desired angle
m
between 0°to 45°. [See miter scale].
Tighten the lock knob for angle adjustment.
m
Power Switch
WARNING!
Before engaging the ON/OFF switch, check
that the saw blade is properly fitted and runs
smoothly and that the blade clamp bolt is
well tightened.
To switch on the circular saw, press the
m
lock-off button and pull the ON/OFF switch
trigger.
When you release the switch trigger the
m
tool turns off.
Parallel Cut Adjustment
Loosen the lock knob of edge guide.
m
Slide the parallel guide through the slots in
m
the shoe to the desired width.
Tighten the lock bolt to fit it in the position.
m
Ensure that the edge guide rests against
m
the wood along its entire length to give a
consistent parallel cuts.
General Cutting
When starting, always hold the saw handle
m
with one hand and the auxiliary handle with
the other hand.
Never force the saw but maintain a light and
m
continuous pressure after completing the cut
allow the saw to come to a complete stop.
When cutting is interrupted, resume cutting
m
by allowing the blade to reach full speed and
then reentering the cut slowly.
Instruction & User Manual
JCB-18CS