JCB -18CS Instrucciones De Funcionamiento página 19

Maintenance
WARNING!
Switch off the tool and disconnect the power
(remove battery/unplug) before cleaning and
maintenance. This helps avoid the risk of
electric shocks and accidental starting.
Wipe the tool with a dry or damp cloth.
m
Do not use a wet cloth. Do not use
detergent that contains solvent or
corrosive, abrasive additives. This risks
damaging the surfaces of the tool.
Clear the tool vents and the accessory
m
mount of dust and dirt after each use.
Do not clean ventilation holes by
inserting sharp objects in them, such
as screwdrivers and other similar
objects.
Stubborn contamination in areas hard to
m
access can be removed with compressed air
(max 3. bar).
Regularly check all fasteners, screws and
m
bolts to make sure that they are tight.
Tighten any loose screws immediately or
serious injury could occur.
WARNING!
Never open the tool. The tool has no
internal parts that the user can service or
repair. Never try to repair the tool yourself.
Take to an authorised service centre.
Transport and Storage
If the tool will remain unused for any length
m
of time, it should be stored in the original
packaging.
Store the tool in a dry, frost-free, well
m
ventilated place.
18
Keep all tools out of the reach of children.
m
Always switch off the tool and disconnect it
m
from the power supply (remove the battery/
unplug the power cord) before transport.
Always carry the tool using the purpose-
m
designed handle.
Ensure that the tool is not at risk of tipping
m
over or exposed to excessive vibration and
shocks during transport, especially if the tool
will be transported by car or other vehicle.
NOTE
Operating temperature: 0~40 °C
Storage temperature: -20~60 °C
Instruction & User Manual
JCB-18CS