Publicidad
Idiomas disponibles
Idiomas disponibles
- Press the
hold for 3 seconds. The shutters start.
- Press button A to exit.
• Your remote control is lost or not functioning
Initial condition: The lost remote control was only
associated with a single motor
Turn off the power to the motor, wait 10 seconds, then
turn the motor back on.
From a new remote control:
- Press the B button 2 times, until the LED flashes orange.
- Press
and
The motor (receiver) has not been associated before
- Restart the association process for your new remote
control.
• The green LED does not flash after briefly pressing
button B.
- Several motors are associated with the remote control.
Therefore, you cannot access the setting modes in this case.
The remote control must only be associated with one
motor for the settings.
and
buttons at the same time and
1
2
for 3 seconds until the flashing stops.
2
1
1
2
2
1
EN
25
Publicidad
