GadgetMonster R/C SHARK Manual Del Usuario página 9

Charging
To charge the shark: On the remote controller change the switch to
"on". On the side of the remote control open the charge lid. Pull out
the charge cable. Insert the charge cable into the charge port in
the mouth of the shark.
A LED turns on to confirm that it is charging. The LED turns off to con-
firm it is fully charged. The shark is ready to be used.
Pull out the antenna on the remote control. Change the switch to
"on" on the remote control.
Put the shark into the water.
Do not place your hands near the tail of the shark, while it is moving.
Make sure there are no obstructions on the shark tail.
When you are done. Take the shark out from the water and wipe it
with a dry cloth.
1. Electric contacts. When it is removed from water, the contacts will
lose connection and the shark will stop moving.
9