Publicidad
Idiomas disponibles
Idiomas disponibles
PHYSICAL INSTALLATION
1. Do not plug in the drill until all plumbing connections are airtight and pump is secure.
2. Connect either the tube or garden hose to the inlet port (marked "IN").
• If using provided tube, first carefully
remove from supplied garden hose, tak-
ing care not to damage the adapter.
Press adapter in as far as it will go.
• If using a hose, be sure the washer is not
missing, broken, or worn.
IMPORTANT: Do not use a hose or tube
longer than 32 in (813 mm).
• For optimum priming and prolonged
pump life, use a few drops of mineral or
cooking oil in pump inlet prior to use.
3. Position inlet tube/hose end into the liquid that is to be moved.
4. Attach a 3/4 in garden hose to the discharge port (marked "OUT") and direct it to where the water is
to be relocated.
5. Attach the pump to the drill following the drill manufacturer's instructions.
OPERATION
High voltages and system pressure capable of causing severe injury or
death are present in this unit.
• To reduce risk of electrical shock, disconnect power before working on or around the system.
• To reduce the risk of electric shock, be certain it is connected only to a properly grounded grounding-type recep-
tacle. A ground fault circuit interrupter (GFCI) is recommended and may be required by code.
Risk of damage to pump or other equipment.
• Do not let the unit run dry (without liquid). It is designed to be cooled by pumping fluid. The seal may be dam-
aged and the motor may fail if the pump is allowed to run dry.
• Do not let the unit freeze, as it may destroy the unit.
1. If applicable, plug the drill's power cord directly into an electrical outlet.
2. Hold both drill and pump securely to prevent rotation.
3. Ensure the drill is set FORWARD (clockwise) position and turn on at full speed.
4. If pump fails to prime in 15 - 20 seconds, make sure the inlet connection is air-
tight and the hose/tube is not kinked or clogged.
5. Unplug the unit as soon as it stops drawing water.
NOTE: Flush pump with clear water after each use to prolong life.
PHYSICAL INSTALLATION
3
Publicidad
