Publicidad
Idiomas disponibles
Idiomas disponibles
2. Raise grate hook and rotate
3. Lift grate and slide out from under grate
bracket
Cleaning The Burner
NOTE: Spiders and small insects can spin
webs and build nests inside the burner. This
especially occurs in late summer and fall
before frost when spiders are most active.
These nests can obstruct gas flow and cause
a fire in and around the burner and orifice.
Such a fire can cause operator injury and
serious damage to the appliance. To help
prevent a blockage and ensure full heat
output, clean and inspect burner tube often
(once or twice a month). NOTE: Water or air
pressure will not normally clear a spider web.
10
Steps for cleaning the Burner:
1. Remove orifice/valve from burner.
2. Look inside the burner tube for nests,
webs, or mud.
3. To remove the gas flow obstructions, use a
flexible venturi brush or bend a small hook
on one end of a long flexible wire or use an
air hose.
4. Inspect and clean the burner if needed.
5. Reattach orifice/hose to burner.
Cleaning and Maintenance
Correct care and maintenance will keep your
appliance operating smoothly. Clean regularly
as determined by the amount of use. NOTE:
Clean the entire appliance each year and
tighten all hardware on a regular basis (1-2
times a year or more depending on usage).
Cleaning should be done where detergents
won't harm patio, lawn, or the like.
Suggested Cleaning Materials
• Mild dish washing liquid detergent
• Wire brush
• Nylon cleaning pad
• Hot water
• Paper clip
• Soft brass bristled brush
Component Cleaning:
• BURNER: Wire brush loose corrosion from
burner exterior. Clean clogged gas port
holes with an opened paper clip. Replace
corroded or damaged burners that would
emit excess gas.
• COOKING SURFACES, POTS AND PANS:
Clean the cooking surface with soapy water
and a nylon cleaning pad.
• After appliance has cooled, wipe areas
where paint and finish have burned off to
minimize rusting.
Publicidad
