Braun PowerBlend 9 JB 9140 Manual Del Usuario página 19

Error code is shown
on the Timer Display
(E01,E02,E03,E04,E05)
18
E01
Overload protection
E02/E03
The thermal protection is
activated to protect the drive
unit from overheating
E04/E05
Turn the blender off, remove
the container from the motor
unit and check if the blade is
blocked.
Follow the recommended
speed, max. filling capacity
or mode in the processing
table.
Turn the blender off, unplug
and wait at least 30 minutes
before resuming operation.
If the error code does not
disappear contact Braun
Customer Service
Turn the blender off and on
again. If the error code does
not disappear contact Braun
Customer Service