Publicidad
Idiomas disponibles
Idiomas disponibles
5. Remove the air cap from the tool air Inlet and connect the
air supply hose to the tool. Set the air pressure at 90 PSI.
6. Push forward the throttle lever lock and press down on the
throttle lever. How far the throttle lever is pressed
determines the tool rotation speed. Then the tool starts to
work.
CARE AND MAINTENANCE
The tool should be lubricated daily (or before each use) with
air tool oil (not included).
Air tool oil is available at major tool hardware stores. SAE 10
weight oil or sewing machine lubricant or any other high grade
turbine oil containing moisture absorbent, rust inhibitors, metal
wetting agents and an EP (extreme pressure) additive may be
used as a substitute. Do not use detergent oil. During
continuous operation, the tool should be oiled every 1 to 2
hours. This may be done using an in-line Oiler, or manually. If
done manually, proceed as follows:
1. Disconnect the tool from air supply.
2. Place a few drops of air tool oil into the air inlet. Avoid the
misuse of thicker oil which may lead to the reduced
performance or malfunction.
3. Connect the tool to the air supply. Run the tool without load
for a few seconds to distribute the oil through the tool. Any
excess oil may be propelled from the collet area. So keep
the tool away in a safe direction.
4. After operating the tool and before storing the tool,
disconnect the air hose and place 4 or 5 drops of air tool oil
into the air inlet, then re-connect the air hose and run the
tool to evenly distribute the oil throughout the tool for 30
seconds approximately. This will prolong the tool life.
5. Avoid storing the tool in a humid environment which
promotes rusting of internal mechanisms. Always oil the
tool before storage.
6. When the tool is seriously damaged or out of life. it should
be left In a resource recvcling can. Never drop it into fire.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Publicidad
