Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
After use, clean in time to prevent food from sticking to surfaces.
•
Clean the power pack surface using a damp cloth. Always wipe dry after cleaning. Never immerse the
motor part in water or rinse it under running water.
•
Do not allow any moisture to enter the interior via any ventilation slots.
•
The appliance contains no user serviceable parts.
Cleaning the shaft, blade guard, and blade
•
Remove the food residue as much as possible.
•
Place the shaft and blade guard into a container with water, then switch on for a few seconds for thorough
cleaning.
•
If necessary, the blade can be removed using the provided blade removal kit for thorough cleaning.
•
WARNING: Always dry the blades well after cleaning to avoid spotting.
•
It is vital to clean thoroughly between each job using a detergent or disinfectant, but never use pure
bleach. For plastic parts, do not use detergents that are too alkaline.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The unit is not
The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Unit stops working
Overheating protection is
suddenly
activated
Loud noise
Blending shaft not correctly
fitted
Blending shaft deformed
Lodged food in the blade
guard surrounding the blade
6
DK849_ML_A5_v2_20240129.indb 6
Insert and lock
Probable Cause
Check the unit is plugged in correctly and switched on
Replace plug or lead
Replace the plug fuse
Check mains power supply
Release the ON/OFF button, then unplug. Wait a few
minutes for the motor to cool down and the thermal
safety mechanism to reset, then restart
Remove and refit
Contact a qualified technician
Turn off, disconnect from power supply and let blender
come to a complete stop. Remove lodged food.
If necessary, manually check the blade and shaft end
are free to rotate while wearing protective gloves. If
problem persists, contact a qualified technician
Loose
Solution
2024/1/29 16:53:22
Publicidad
