ENGINE WILL NOT START
C A U S E
Blue EZ-Start lever wasn't flipped/set
Throttle lever is in the incorrect position
Empty fuel tank
Primer bulb wasn't pressed enough
Engine flooded
Old or improperly mixed fuel
Fouled spark plug
Plugged spark arrestor
The outside temperature is below 40º F
The outside temperature is above 90º F
ENGINE WILL NOT IDLE
C A U S E
Air filter is plugged
Old or improperly mixed fuel
Improper carburetor adjustment
ENGINE WILL NOT ACCELERATE
C A U S E
Old or improperly mixed fuel
Improper carburetor adjustment
Dirty air filter
Plugged spark arrestor
ENGINE LACKS POWER OR STALLS
C A U S E
Old or improperly mixed fuel
Air filter is plugged
Improper carburetor adjustment
Fouled spark plug
Plugged spark arrestor
UNIT WILL NOT BLOW OR VACUUM
C A U S E
Bag full
Blocked tube
Blocked impeller
Damaged impeller
If further assistance is required, contact your authorized service dealer.
TROUBLESHOOTING
Call 1-800-520-5520 for more information.
A C T I O N
Move lever to the starting position
Refer to the Starting/Stopping instructions
Fill fuel tank with properly mixed fuel
Press primer bulb fully and slowly 10 times
Flip throttle lever to FAST and pull starter rope
Drain gas tank / Add fresh fuel mixture
Replace or clean the spark plug
Clean or replace spark arrestor
Pull the starter rope up to 10-15 times
Squeeze the throttle control and pull the starter rope
A C T I O N
Replace or clean the air filter
Drain gas tank / Add fresh fuel mixture
Adjust according to the Carburetor Adjustments section
A C T I O N
Drain gas tank / Add fresh fuel mixture
Take to an authorized service dealer for
carburetor adjustment
Clean or replace the air filter
Clean or replace spark arrestor
A C T I O N
Drain gas tank / Add fresh fuel mixture
Replace or clean the air filter
Take to an authorized service dealer for
carburetor adjustment
Replace or clean the spark plug
Clean or replace spark arrestor
A C T I O N
Empty bag, as described in Empty the Vacuum Bag
Clear the blockage as described in Clearing a Blocked
Tube/ Impeller
Clear the blockage as described in Clearing a Blocked
Tube/ Impeller
Take the unit to an authorized service dealer
19