Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE AND REPAIR INSTRUCTIONS
6. Pull the line from the outer spool until the line is tight
against the inner reel (Fig. 44).
Fig. 44
7. Repeat procedures 4-6 with the second piece of line.
8. Hold the outer spool. Wind the inner reel
counterclockwise until approximately four (4) inches
(102 mm) of line remain (Fig. 45).
NOTE: Do not wind the inner reel before installing the
second piece of line.
Fig. 45
9. If winding the line becomes difficult or if the line
jams, pull the ends of the line from the spool
(Fig. 46). Continue winding the inner reel
counterclockwise until approximately 6 inches of line
is left.
Fig. 46
20
INSTALLING A PRE-WOUND REEL
1. Turn the bump knob counterclockwise and remove
the bump knob, spring and foam seal (Fig. 47).
Bump Knob
Foam Seal
Spring
Inner Reel
Fig. 47
2. Pull the old inner reel with existing line from the outer
spool.
3. Insert the ends of the prewound inner reel line into
the outer spool eyelets (Fig. 48). Push the new inner
reel, arrow side up, into the outer spool.
Fig. 48
4. Hold the inner reel in place and install the bump
knob, spring and foam seal (Fig. 47). Press down
and turn the bump knob clockwise. Grasp the ends
and pull firmly to release the line from the holding
slots in the inner reel.
Releasing the Inner Reel
®
If the SpeedSpool
does not release line correctly, pull
the ends of the line firmly from the spool (Fig. 46). If this
does not the release line, follow the Cleaning the
®
SpeedSpool
instructions.
CLEANING THE SPEEDSPOOL
Cleaning the SpeedSpool
•
A jammed or excessive line must be removed
®
•
The SpeedSpool
becomes difficult to wind or does
not operate correctly when bumping the head on the
ground
1. Hold the outer spool, and unscrew the bump knob
counterclockwise (Fig. 49).
2. Pull out the bump knob, spring and foam seal (Fig. 47).
®
®
may be necessary if:
Publicidad
