Fcc Warning; Fcc Note - Kenwood KDC-BT648U Manual De Instrucciones

FCC WARNING

This equipment may generate or use radio
frequency energy. Changes or modifications
to this equipment may cause harmful
interference unless the modifications are
expressly approved in the instruction manual.
The user could lose the authority to operate
this equipment if an unauthorized change or
modification is made.

FCC NOTE

This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment may cause harmful interference
to radio communications, if it is not
installed and used in accordance with the
instructions. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
■
Increase the separation between the
■
equipment and receiver.
Connect the equipment into an outlet on
■
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
■
TV technician for help.
Contains Transmitter Module
■
FCC ID : RKXCK5000NVIA
Contains Transmitter Module
■
IC : 5119A-CK5000NVIA
IC (Industry Canada) Notice
Operation is subject to the following two
conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause
undesired operation of the device.
The term "IC: " before the certification/
registration number only signifies that the
Industry Canada technical specification were
met.
Note de 'IC (Industrie Canada
L'utilisation de ce dispositif est autorisée
seulement aux conditions suivantes:
(1) Il ne doit pas causer d'interférence, et
(2) l'utilisateur doit accepter tout brouillage,
y compris les interférences pouvant
compromettre le fonctionnement de cet
appareil.
L'expression "IC: " avant le numéro
d'homologation/enregistrement signifie
seulement que les spécifications techniques
d'Industry Canada ont été respectées.
2CAUTION
Use of controls or adjustments or performance
of procedures other than those specified
herein may result in hazardous radiation
exposure.
In compliance with Federal Regulations,
following are reproductions of labels on, or
inside the product relating to laser product
safety.
Kenwood Corporation
2967-3, ISHIKAWA-MACHI,
HACHIOJI-SHI
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS N0.21 CFR
1040. 10, CHAPTER 1, SUBCHAPTER J.
Location : Top Panel