Mellerware OPTIMA 62600C Manual página 4

3.2.10. Remove the blade assembly by turning it anti
clockwise.
3.2.11. Remove the blade assembly.
3.2.12. Use the clear cup of the coffee grinder to fill
with the food to be ground up.
3.2.13. Lower the blade assembly back into the clear
cup and lock into place by turning it clockwise.
3.2.14. Turn the assembled coffee grinder the right way
up (clear cup facing upwards).
3.2.15. Place the coffee grinder onto the base and ap-
ply downwards pressure.
3.2.16. Use the speed selection knob in short bursts
until the desired consistency is reached.
3.2.17. Remove the coffee grinder.
3.2.18. Turn the coffee grinder upside down and
remove the blade assembly
Useful tips:
•To achieve the best results when pureeing solid in-
gredients, place small portions into the jug one by one
instead of placing a large quantity inside all at once.
•If you are processing solid ingredients, cut them into
small pieces (2-3cm) first.
•When mixing solid ingredients, start off first with
a small amount of liquid. Gradually add the solid
ingredients and then more liquid through the opening
in the lid.
•Always place your hand on top of the blender while it
is in use
3.3 Once you have finished using the appliance:
3.3.1. Allow appliance to cool down.
3.3.2. Unplug the appliance from the mains power
supply.
3.3.3. Clean the appliance as described in the cleaning
section.
4. Cleaning
4.1. Disconnect the appliance from the mains power
supply and allow it to cool completely before undertak-
ing any cleaning task.
4.2. Empty the jug of its contents and fill it with water
(bear in mind the maximum capacity). Place the jug on
the motor base and press the Pulse button. This will
loosen most of the left over ingredients in the jug.
4.3. Empty the jug and rinse the inside of the jug to
remove any traces of food.
4.4. Always excercise extreme caution when cleaning
the inside of the jug as the blades are sharp.
62600C_IM..indd 4
4.5. Clean the outer parts of the appliance with a damp
cloth with a few drops of washing-up liquid and then
dry. CAUTION! Do not immerse electrical parts of the
appliance in any liquid.
4.6. Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive products, for
cleaning the appliance.
4.7. Never submerge the appliance in water or any
other liquid or place it under running water.
5. Anomalies and repair
5.1. Take the appliance to an authorised support centre
if product is damaged or other problems arise.
5.2. If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
2019-10-07 02:01:40 PM