Hama Premium Instrucciones De Uso página 7

Risk of electric shock
• Do not open the device or continue to operate it if it
becomes damaged.
• Do not use the product if the AC adapter, adapter cable or
power cable is damaged.
• Do not attempt to service or repair the product yourself.
Leave any and all service work to quali ed experts.
Warning – Batteries
• When inserting batteries, note the correct polarity (+ and
- markings) and insert the batteries accordingly. Failure to
do so could result in the batteries leaking or exploding.
• Only use batteries that match the speci ed type. Keep the
instructions for the correct choice of batteries included
with the operating instructions of devices safe for future
reference.
• Before you insert the batteries, clean the battery contacts
and the polarity contacts.
• Do not allow children to change batteries without
supervision.
• Replace all the batteries in a set at the same time.
• Do not mix old and new batteries, or batteries of different
types or from different manufacturers.
• Remove the batteries from products that are not being
used for an extended period (unless these are being kept
ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries or heat them up.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
• Remove spent batteries from the product and dispose of
them without delay.
• Avoid storing, charging and using in extreme temperatures
and at extremely low atmospheric pressures (such as at
high altitudes).
• Ensure that batteries with damaged housings
do not come into contact with water.
• Keep batteries out of the reach of children.
4. Getting Started
Note
Before use, ensure you insert the batteries in the measuring
station rst and then in the base station.
4.1 Insert batteries / connect power supply
Measuring station
• Remove the screen protector from the display.
• Open the battery compartment (C5) and remove the contact
breaker.
• Then close the battery compartment cover.
Base station
Warning
• Connect the product only to a socket that has been
approved for the device. The socket must be installed close
to the product and must be easily accessible.
• Disconnect the product from the network using the power
button – if this is not available, unplug the power cord
from the socket.
• When using a multi-socket power strip, make sure that
the sum power draw of all the connected devices does not
exceed its maximum throughput rating.
• If you will not be using the product for a long period of
time, disconnect it from mains power.
• Remove the screen protector from the display.
• Connect the power supply unit to the power supply unit
connection socket (B10) on the back of the base station.
• Connect the power cable of the weather station to a properly
installed socket.
• Alternatively, open the battery compartment (B12), insert
two AA batteries with the correct polarity and close the
battery compartment cover.
Note
If the batteries are inserted correctly and you connect the
power supply unit to the station, the base station will
automatically switch to the external power supply.
5. Installation
Note
• The wireless transmission range between the measuring
and base stations is up to 50 m in open spaces.
• Before installation, ensure that wireless transmission will
not be disrupted by interference or obstacles like buildings,
trees, vehicles, high-voltage lines, etc.
• Before the nal installation, ensure that there is su cient
reception between the intended installation locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage
the product.
• Before installation, ensure that the chosen wall is suitable
for the weight to be mounted, and make sure that there
are no electrical wires, water, gas or other lines at the
installation site on the wall.
• Do not mount the product above locations where persons
might linger.
6