Publicidad
Idiomas disponibles
Idiomas disponibles
LIGHTING
LIGHT REPLACEMENT
● Switch off the extractor hood and isolate the extractor hood by pulling out the mains plug or
switching off the fuse.
● Remove the grease filter.
● Remove the light by levering its fitting from the hood body(this may require pressure or force to
be applied).
LED modules
separate
ballast
● Disconnect the connector of the light.
● Replace the light with a new one of the same type,
making sure that you connect the light with the light
cable correctly.
● Reinstall the light back to the hood body.
DC 12 V
Round/Diameter:70mm
10
/
DSR-1.5-S-70
Publicidad
