Descargar Imprimir esta página

Coleman Powermate PM0463300 Guia página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
TOOLS REQUIRED: 7/16" wrench, 3/4" socket and ratchet.
Refer to the parts list and drawing on pages 8 and 9.
WHEEL INSTALLATION
1. Slide 1/2" x 4.50" bolt (item 41) through the wheel
(item 33),then through the wheel bracket, with the offset
side of the wheel hub against the wheel bracket.
2. Thread 1/2" nyloc nut (item 42) onto the bolt and tighten.
3. Repeat above instructions for the remaining wheel.
FOOT INSTALLATION
1. Assemble the foot (item 44) to the carrier channel using a
1/4" x 2.00" bolt (item 43). Thread a 1/4" washer
(item 17) and a 1/4" nyloc nut (item 15) onto the bolt to
secure the assembly.
Caution: Do not over tighten so that the foot material
collapses.
2. Repeat above instructions for the remaining foot.
HANDLE INSTALLATION
1. Slide the reduced ends of the handle (item 18) into the
upright tubes of the base as shown in the diagram.
2. Install the 1/4" x 2.00" bolts (item 43) through the tubes
from the outside.
3. Thread the 1/4" nyloc nuts (item 15) onto the bolts and
tighten.
NOTE: Do not over tighten.
PROBLEM
Unit will not idle
Unit idles even with load plugged in
Unit tries to idle but won't stay latched Electro-magnet or solenoid position
English
IDLE CONTROL TROUBLE SHOOTING
POSSIBLE CAUSE
Control panel switch not on
Load plugged into receptacle
Poor connection or faulty cord
Bad I.C. module; Bad electro-magnet
or solenoids; Bad stator
Load not heavy enough
Bad I.C. module
incorrect
Flapper bracket loose or bent
Engine not running smoothly
IDLE CONTROL OPERATION
The Idle Control circuit is designed to extend engine life
and improve fuel usage by slowing the engine down to
approximately 2000 RPM in a "No Load" condition. The noise is
also greatly reduced during this condition.
When power is required from the generator an electronic
control module automatically senses current flow in the
electrical outlet and allows the engine to return to full speed or
standard operating condition. Likewise, when the load is
removed, the generator will automatically return to the idle
condition after a 4-5 second delay.
A convenient switch is mounted in the control panel for
easy access and will disable the Idle Control circuitry when in
the off position.
SOLUTION
Turn to idle on position
Unplug load
Check & repair
Replace
Consult dealer
Turn idle switch to off position
Increase load
Replace
Consult dealer
Reset magnet or solenoid position for
2000 RPM idle speed
Consult dealer
Tighten or straighten
Replace flapper. Readjust to 2000 RPM
Adjust carburetor
Consult dealer
3

Publicidad

loading