Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Specifications, HPR151i and HPR181i
Frequency Response, -3dB
Frequency Range, -10dB
Maximum Peak SPL
Nominal coverage, H x V
Transducer Description
Amp Power
Input Sensitivity
Input Headroom/Clipping
Input Connectors/Impedance
Output Connectors
Controls, Indicators, and
Adjustments
Protection, Agency certs.
AC Power Requirements
AC Power Connector and Cordset
Dimensions
Weight
Finish and Grill
Notes:
1- Maximum Peak SPL: Calculated by adding the loudspeaker's sensitivity (1W at 1m) to the peak power (dBw) of the amplifier provided.
2- Directivity Index (DI): Difference between on-axis SPL and average SPL (considering all axes) for the specified coverage range. DI= 10 log Q
3- Directivity Factor (Q): Directivity index expressed as a power ratio Q=10 exp DI/10
4- Amplifier Power: The maximum sustained power at less than 1% clipping, averaged over the intended frequency range,
5- Input Sensitivity: The sine-wave input voltage required to reach amplifier clipping, measured within the frequency range used to determine Maximum Peak SPL, with the gain on "normal" and no gain reduction due to
limiting.
6- Input Headroom/Clipping: Maximum input voltage.
7- Input Connector/Impedance: RF shunt capacitance should not reduce impedance by more than 30% at 20k Hz.
HPR151i
51-105 Hz
43-145 Hz
133dB
Not applicable (N/A)
15" (381mm) transducer with 3" (76mm) voice coil
700 Watts
0.775 V
(+0dBu)
rms
10 V
(+22.2dBu)
rms
Two XLR female, 22k Ohm, balanced, left and right (L+R) inputs (11k Ohms unbalanced)
Four XLR male: two wired in parallel with Input connector (full range), two post-100 Hz low-cut filters
Gain control, Polarity switch (normal/reverse), Front LED on/off switch, Limit/Clip (red LED), Signal presence (green LED), AC Power (blue LED)
AC Power switch, AC circuit breaker
Thermal limiting, On/Off muting, power limiting, DC protection, short circuit protection, ultrasonic protection, RF protection, UL/CE listed
Factory supplied IEC cordset: 9' (3m) #18AWG 120V North American or European 230V cordset
25.6" (651mm) x 22" (559mm) x 20.7" (525mm)
98 lb/44.5 kg
Wear-resistant textured paint finish with powder-coated perforated steel grill
HPR181i
45-95 Hz
39-145 Hz
134dB
Not applicable (N/A)
18" (457mm) transducer with 4" (102mm) voice coil
700 Watts
0.775 V
(+0dBu)
rms
10 V
(+22.2dBu)
rms
28.6" (727mm) x 23.5" (597mm) x 22.9" (582mm)
127 lb/57.6 kg
23
Publicidad
Tabla de contenido
