Trafimet ERGOPLUS 240 Manual De Istrucciones página 7

CONNECTION
Before connecting the
torch, switch off the
power source, disconnect
the power plug and shut
off the gas supply.
USE
Make sure that the wire
liner and contact tip
match the diameter of
the filler wire.
MAINTENANCE
Turn off the power source
before performing torch
maintenance. Replacement
of any spare parts or other
maintenance must be
performed after the torch
has cooled down.
All trademarks are the property of their respective owners. The information and images are indicative and may be subject to change at any time without notice. © 2023 Trafimet Group SpA
Before connecting
the torch to the power
source, check the correct
electrical connections
according to the enclosed
wiring diagrams, where
applicable.
Do not bend cables and
hoses in order to avoid
damages that may prevent
proper gas and coolant
circulation.
Replace the contact tip if
it is worn or damaged.
Replace the wire liner if
there are problems with
the wire feed.
Check the torch coolant
circulation/flow.
Do not use the torch
for purposes other than
welding.
Clean the gas nozzle
and gas diffuser
periodically. Use anti-
adhesive spray.
Check the condition of
the cable and handle
periodically. Repairs
may be carried out by
qualified personnel only.
Always use the original
Trafimet spare parts and
consumables.