Publicidad
Idiomas disponibles
Idiomas disponibles
USE
Disconnect the device from air source.
Loosen and remove the Allen screw (9).
Remove the abrasion protection (2).
Loosen and remove the Allen screw (1) of the output shaft.
The adapter for round wire brushes
consists of two halves.
Disassemble the adapter.
Insert the round wire brush and put on the
upper half of the adapter.
The adapters have a internal hexagon on one
side.
Place this internal hexagon on the outer hexagon
of the output shaft and fix the adapter with the
Allen screw.
The handle can be swiveled through 180°.
Turn the handle counter-clockwise to adjust (fig.1), move the handle to the desired position, and
turn the handle clockwise to lock (fig.2).
The safety lever prevents accidental switching on (fig.1).
To switch on the machine, tilt the safety lever (fig.2) and pull the trigger lever towards the handle
(fig.3). The machine starts.
Fig. 1
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Fig. 1
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Fig. 2
Fig. 2
Fig. 3
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
