Off Indel B CR86 Instrucciones De Uso página 21

Idiomas disponibles

REPLACING THE DOOR PANEL

You can replace the door panel without having to dismantle the door of the refrigerator, by proceeding as follows: remove

the profile which anchors the panel, locate at the bottom of the door, using a screwdriver as a lever as shown on Fig 6, take

out the three screws which hold the handle in place (fig. 8), fit in the new panel, letting it slide, and put back the fastening strip

and the handle.

REVERSING THE OPENING DIRECTION OF THE DOOR

The door normally opens towards the right. To change the side, move the hinges, the support (A, B and C in fig. 7) and the

handle (fig. 8).

SETTING THE INSIDE TEMPERATURE

The refrigerators are provided with a manual thermostat. Turn it clockwise to lower the temperature, and turn it

counterclockwise to raise the temperature and activate the ON-OFF switch in its end position. The knob of the thermostat is

located inside the refrigerator (fig. 9).

FILLING

Do not put hot food into the refrigerator. Place the products in a position where they do not hit each other or break while the

vehicle is moving.

Make sure the door is always well closed, and reduce opening time to a minimum.

DEFROSTING

Defrosting must be carried out when the ice layer is thicker than 4 mm.

Set the thermostat at the OFF position. While defrosting, keep food and beverages in a cool place. Do not use any sharp

metal object to remove the ice or frost. Do not start the refrigerator up again until it is completely defrosted and dry. Also

empty the tray under the freezer compartment.

OFF IS A BRAND OF INDELB