Schluter Systems DH E RT2 / BW Manual De Instrucciones página 7

INTRODUCTION
The thermostat is an electronic PWM/PI thermostat for tem-
perature control by means of an NTC sensor located either
externally or internally within the thermostat.
The thermostat is for flush mounting in a wall socket. A base-
plate for wall mounting is also available.
Fig. 1 - Content
• Thermostat
• Sensors
• Display disassembly tool
This thermostat can be used as a controller for electric room
heating pursuant to EN50559.
Product programme
DH E RT2 / BW Clock-thermostat with two sensors:
DH E RT6 / BW Smart thermostat with WiFi, App & Voice
IMPORTANT SAFETY INSTRUCTIONS
Fig. 2 - Warnings
To avoid electric shock, disconnect the heating
system power supply at the main panel before
carrying out any work on this thermostat and
associated components.
Installation must be carried out by qualified personnel in
accordance with appropriate statutory regulations (where
required by law).
Installation must comply with national and/or local electrical
codes.
© 2022. All rights reserved. Used under license by Schlüter-Systems KG
DH E RT2 / BW
(MCD5-1999-SLP3)
DH E RT6 / BW
(MWD5-1999-SLC3)
Instruction
English
floor sensor and built-in room sensor.
Control, floor sensor and built in room sensor.
7