Metabo S 18 LTX 115 Instrucciones De Manejo página 9

PE 17-200 RT:
Torque activation (with dead man's lever)
I
Switching on: Slide the trigger switch (12)
forwards and then push the trigger switch
(12) upwards.
Switching off: Release the trigger switch (12).
Continuous operation (depending on features)
I
Switching on: Switch the machine on as described
above. Now slide the trigger switch (12)
forwards again and release in the front
position to lock the trigger switch (12)
(continuous operation).
Switching off: Push the trigger switch (12)
upwards and release.
7. Attaching the tools, working
notes
Press in the spindle locking knob (8) only
when the spindle is stationary!
7.1 Tools with threaded insert:
1. Remove the tensioning spindle (14) if
necessary. Press in spindle locking button (8)
and hold in place. Unscrew the tensioning
spindle using the open-ended spanner (15).
2. Press in spindle locking button and hold in place.
3. Screw the tool onto the spindle and tighten.
7.2 Tools for tensioning spindle:
- Attach the tensioning spindle (14) if necessary.
Press in spindle locking button (8) and hold in
place. Tighten the tensioning spindle using the
open-ended spanner (15).
- Slide the tool onto the tensioning spindle.
- Press in spindle locking button (8) and hold in
place.
- Screw the tool fixing screw (13) onto the
tensioning spindle and tighten (the spindle locking
knob engages and the tool can be secured).
If the tools used are shorter than the
tensioning spindle, insert the relevant distance
sleeves (16). This is the only way to properly secure
the tool.
12
0
12
0
7.3 Working Directions
Sanding, polishing, working with wire brushes:
Apply moderate pressure on the machine and move
it to and fro across the surface
8. Maintenance
Disconnect the mains plug or remove the battery
pack from the machine before starting any
maintenance work.
It is possible that particles deposit inside the power
tool during operation. This impairs the cooling of the
power tool. Conductive build-up can impair the
protective insulation of the power tool and cause
electrical hazards.
The power tool should be cleaned regularly, often
and thoroughly through all front and rear air vents
using a vacuum cleaner or by blowing in dry air.
Prior to this operation, separate the power tool from
the power source and wear protective goggles and
a dust mask.
9. Troubleshooting
9.1 Mains powered machines
The electronic signal indicator (10) lights
up and the load speed decreases (not
W...RT). There is too much load on the
machine! Run the machine in idling until the
electronic signal indicator switches off.
The machine does not start. The
electronic signal indicator (10) flashes
(depending on the model). The restart
protection is active. If the mains plug is inserted with
the machine switched on or if the power supply is
restored following an interruption, the machine
does not start up. Switch the machine off and back
on again.
9.2 Cordless machines
- The electronic signal indicator (10) lights up
and the load speed decreases. The
temperature is too high! Run the machine in idling
until the electronic signal indicator switches off.
- The electronic signal display (10) flashes and
the machine does not start. The restart
protection is active. The machine will not start if
the battery pack is inserted while the machine is
on. Switch the machine off and back on again.
10. Accessories
Only use original Metabo battery packs and Metabo
accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
Batter chargers: ASC Ultra, ASC 30-36, etc.
Battery packs with different capacities. Use
battery packs only with voltage suitable for your
power tool.
ENGLISH en
9