Descargar Imprimir esta página

Korg KAOSS Replay Guia De Inicio Rapido página 6

Publicidad

1.
Connect the included AC adapter cable to the [DC IN] jack on the rear
panel of the unit.
2.
Plug the AC adapter to an outlet.
3.
Connect instruments and external devices as needed.
(Connection example)
CD PLAYER
MIXER
AUDIO PLAYER
HEADPHONES
En-4
FOOT SW
AUDIO I/F
PC
Included
AC adapter
MIC
Use a cable that's no more than 3 m long when connecting your external devices to
this unit.
NOTE
4.
Set the volume of all the devices to the minimum level.
To adjust the volume of this unit, use the following knobs.
• Adjustment of input volume level
- [LINE/PHONO IN]: [INPUT VOLUME] knob
- [MIC] jack: [MIC TRIM] knob
• Adjustment of output volume level
- [AUX IN] input and [LINE OUT]: [OUTPUT VOLUME] knob
- GROUP A(/B): [LEVEL] fader of GROUP A(/B)
- Headphones: [PHONES VOLUME]: knob
5.
Turn on this unit and the external device.
Be sure to follow the order described below. If an excessively loud sound is output, it
may lead to a hearing impairment or device failure.
NOTE
• Turn the unit/devices on in the following order: input device -> this unit -> output device.
• Turn the unit/devices off in the following order: output device -> this unit -> input device.
[POWER] switch: Turns the unit on and off
(To turn the power off, hold down this switch for a few seconds.)
6.
Adjust the volume of the [LINE/PHONO IN] jack.
1. Press the [LINE/PHONO] button (the button lights up), and turn on the LINE/PHONO
input.
2. Play the input device such as a CD player.
3. Adjust the volume level using the [INPUT VOLUME] knob until the [SIGNAL/PEAK] LED
momentarily lights up red.
• If the LED does not light up, also adjust the output volume of the CD player or
other devices.
HINT
• To connect a record player, set the [INPUT SEL] switch to [PHONO] (pressed state).
* Before operating the [INPUT SEL] switch, be sure to set the volume of this unit
and the connected devices to the minimum level.
• Use the [PHONO GAIN] switch to adjust the gain as needed.
* Before operating the [PHONO GAIN] switch, be sure to turn off this unit and all
the devices connected to this unit.

Publicidad

loading