Publicidad
Idiomas disponibles
Idiomas disponibles
• The ice boxes provided increase the cool effect: before use, fill them
with water and put in the refrigerator until they are completely frozen.
After that insert the frozen ice boxes in the water tank making sure that
water level is under maximum level allowed.
• To deactivate this function press again cooler button. If the evaporative
cooling function is deactivated the unit work as a fan.
HEATER button (E):
• Press Heater button to turn on the unit in heating mode and select the
desired power level: minimum (indicator light 2) or maximum (indicator
light 3).
TEMPERATURE button (F):
• Press Temperature button (in heating mode) to select the desired
ambient temperature: 20°C (indicator light 7), 25°C (indicator light 8)
or 30°C (indicator light 9).
ATTENTION
» Temperature button (F) can be pressed only in heating mode.
» Desired temperature have to be setted every time you change heating
power level (E button).
» If the setted temperature is lower than ambient temperature, the unit
enter in stand-by mode and it will turn on automatically when the
ambiente temperature will be lower than setted temperature.
Before carrying out routine cleaning, switch off the fan and disconnect
mains power. For external cleaning use a soft and dry cloth.
DO NOT dip the device in water, or splash it with any other liquids.
DO NOT use solvents or any other chemical products for cleaning it.
When you do not use it, after cleaning it, store the fan in a dry place.
DAILY CLEANING
To reduce bacteria and scale residues, empty the water tank every day
after use and dry it with a soft and clean cloth.
Cleaning the anti-dust filter, cleaning the cooling pad:
Remove it from the appliance by pulling it out. Clean it with water and
replace on the appliance when dry. Fix the anti-dust filter with its screw.
Attention: the cooling pad and the anti-dust filter must be replaced in the
appliance before turn it on.
26
Maintenance
GB
Publicidad
