Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
If replacing an older faucet
ensure water supply is turned
OFF before removing, then
turn faucet control valve ON
to relieve water pressure.
DO NOT use pipe dope
or thread sealant on drain
assembly, or any plastic
threaded components.
1) Insert supply lines (M) and threaded
rods (L) through escutcheon (K)
and sink hole.
M
2) Place rubber washer (N), metal
washer (O) onto threaded rods (L).
Secure with nuts (P).
L
N
O
P
1
Note: Hoses removed for clarity.
3) Push Pop Install: Insert drain
body (L) into drain opening. From
below, Tighten locking nut (O)
with gasket (M) and washer (N)
to flange. Tighten tail nut (Y) with
washer (X) to secure tail pipe (Q).
DO NOT overtighten.
Plumbers Putty
L
4) Attach supply lines (M) to shut-off
valves and hand tighten. Using a
wrench, finish with one-half turn.
K
DO NOT overtighten.
5) Remove flow restrictor (J) and flush
supply lines free of debris. Check
for leaks.
2
L
1
M
N
2
O
X
3
Q
Y
M
1
1
2
3
6) Optional: Adjust limit stop washer
to limit handle turn to the hot
position if desirable.
2
1
Note: Counterclockwise to lower
temperature, clockwise to increase
temperature.
J
3
Publicidad
