Technical Data; Troubleshooting - LATICRETE LATAPOXY 310 Manual De Instrucciones

10. TECHNICAL DATA

Cordless Mixer Tool Weight
Cordless Mixer Dimensions
Battery Information
Charger Information
11. TROUBLE SHOOTING
Please review the attached trouble shooting guide. For any other questions or assistance, please contact LATICRETE
PROBLEM OBSERVED
Trigger depressed, motor does not start
Trigger depressed, motor running but
material is not being dispensed
Material dispensing slowly
Dispensed LATAPOXY 310 Stone Adhesive
is not uniformly mixed
Rack handle difficult to
8 lbs. (3.63 kg)
17" x 3.5" x 12.5" (43 x 9 x 31.75 cm)
20 Lithium Ion
~30 minutes
POSSIBLE CAUSES
Battery drained or low
n
Speed control knob turned down
n
Battery not fully inserted
n
Cartridge fully dispensed, mixer shuts
n
Clutch is disengaged
n
Cartridge tip not removed
n
LATAPOXY 310 Stone Adhesive too cold
®
n
Adhesive has cured in mixing nozzle
n
Cartridge failure (blow by)
n
Battery too low
n
Speed setting low
n
LATAPOXY 310 Stone Adhesive too cold
n
LATAPOXY 310 material partially cured in nozzle
n
Cartridge failure (blow by)
n
Material too cold
n
Material curing in nozzle
n
Cartridge failure (blow by)
n
Clutch closed, engaged
n
Technical Services at 800.243.4788, ext. 1235.
®
RECOMMENDED SOLUTIONS
Recharge battery
n
Increase speed setting
n
Remove and reinstall battery
n
Remove used cartridge off automatically and replace with new
n
Close clutch lever
n
Remove tip
n
Condition material to at least 65°F (18°C)
n
Change Mixing Nozzle
n
Remove cartridge. Clean pistons and teeth. Install new cartridge
n
Recharge battery
n
Increase setting
n
Condition material to at least 65°F (18°C)
n
Replace mixing nozzle
n
Remove cartridge. Clean pistons and teeth. Install new cartridge
n
Condition material to at least 65°F (18°C)
n
Change mixing nozzle
n
Remove cartridge. Clean pistons and teeth. Install new cartridge
n
Open clutch, pull rack back
n
10