Publicidad
Idiomas disponibles
Idiomas disponibles
6. Attach seat side covers over backrest brackets using
two M5 x 10 mm bolts. Place caps over bolt holes
once tightened. Repeat for opposite side.
(See Figure 6)
NOTE: Inside of seat side covers are marked
"L" for left side and "R" for right side installation.
4
6A
5
1
PAGE 3 OF 9
ASSEMBLY CONTINUED
CHAIR ADJUSTMENTS
1.
2. Upright Tilt Lock – To lock chair in an upright position,
3. Tilt Tension – To increase tilt tension, turn knob
6B
6C, 6D
4. Adjustable Lumbar Support – To increase lumbar
5. Back Recline – To recline backrest, pull up on lever
6. Armrest Adjustment
2
3
1-800-295-5510
uline.com
Figure 6
Cap
M5 x 10 mm Bolt
Seat Height Adjustment – To raise seat height, lift
lever up with little to no weight on the seat. To lower
seat height, lift lever up while sitting.
push the lever down. To restore tilt, pull the lever up.
Chair has synchronized knee tilt; the pivot point is
located near the front edge of the chair.
clockwise. To decrease tilt tension, turn knob
counterclockwise.
support, turn knob clockwise. To decrease lumbar
support, turn knob counterclockwise.
to engage. Release lever to lock in recline.
A. Height – Pull lever under outside of armrest pad
and move the armrest up or down.
B. Width – Push button under inside of armrest pad
and move the armrest in or out.
C. Depth – Push button on inside front of armrest
pad to move the armrest front or back.
D. Pivot – Push button on inside front of armrest to
pivot the armrest in or out.
0224 IH-11087
Publicidad
