Publicidad
Idiomas disponibles
Idiomas disponibles
7. Attach Side Back Panels (K) to the back
of the completed assembly from step 6.
Use a Phillips Head Screw Driver,
tighten Wood Screws (Q) through the
pre-drilled holes in the Side Back Panels
(K).
8. Rest Center Back Panel (J) onto the base
of the console as shown in diagram (D-5).
Allow the pre-installed magnets to keep
the Center Back Panel (J) in closed
position.
9. Attached the Hinge (X) to the Left Front
Door (R) and Center Left Front Door (S),
tighten the Hinge Screws through the
pre-drilled holes, following Diagram
(D-6, figure 1).
And repeat for the opposite side.
Two adult are required for step 8!
10. Locate Hinge Screws, with one
person holding the Left Front Door (R)
another person secures the adjustable
side of Hinge (X) to the console wall
using Screws, following Diagram
(D-6, figure 2).
And repeat for all doors.
TO ADJUST HINGES
To adjust door forward or backward
change keyhole slot position.
(As Shown In Diagram 3a)
To adjust door right or left
loosen/tighten screw.
(As Shown In Diagram 3b)
To adjust door up or down adjust
bracket height.
(As Shown In Diagram 3c)
11. Attach the Knob (V) to the Center Left
Front Door (S) and Left Front Door (R),
use the bolts attached through the
pre-drilled holes in the doors. Then use a
Phillips Head Screwdriver to tighten the
bolts.
And repeat for opposite side.
E-4
Q
Q
K
Center
Side
Back
Back
Panel
Panel
1
2
Hinge
X
R
S
Center
Right
Center
Front
Left
Door
Left
Front
Front
Door
Door
Meijer.com
K
Side
J
Back
J
Panel
D-5
3
c
a
b
Right
Front
Door
U
T
V
Knob
D-6
Publicidad
