Nova LAUS Manual De Instrucciones Y Garantía página 5

GB
Do not unplug by pulling the cord. to unplug, take the plug, not the cord.
Do not handle plug or steam cleaner with wet hands or operate without shoes.
If the supply cord is damaged , it must be replaced by the manufacturer or by its technical service centre or in
any case by qualified personnel.
Do not put any object into openings and do not use it in case of any plugged openings or nozzles.
store the steam cleaner inside, in a cool, dry area
keep Your work area well lighted
keep the appliance always in horizontal position while working and never turn it more than 45 degrees re-
spect to the vertical axis. never direct steam towards people, animals, plants and equipment with electrical
components.
Do not dip the steam cleaner into water or other liquid. always unplug the power cord from the electrical socket
when filling the tank.
never put descaling, aromatic or detergent products into the tank, as this may damage it or make it unsafe for
use.
Metal tips and nozzles will get hot during use. Do not touch their surfaces. allow them to cool down before
replacing them .
any maintenance operation, including the replacement of the power cord, has to be carried out by qualified
personnel.
the cover must be tighten while using the appliance.
Do not use it in swimming pools containing water.
before filling, proceed as follows : 1. unplug the power supply 2. release pressure by pressing on the pressure
button 3. allow steamer to cool down for about 3 minutes. 4. relieve any residual pressure by acting again on
the pressure button 5. unscrew slowly the safety cap and wait for 5 seconds before removing it.
1)CAUTION
Do not overfill the tank. It can create unnecessary steam pressure and influence steam
production.
2)DANGER OF SCALDING !
When the tank is under pressure, push the steam button to release pressure before ope-
ning.
LIBRETTO.indd 11 13-06-2006 10:05:22