Giatsu AROMA 2E Serie Manual De Usuario página 40

USER MANUAL
PROBLEM
The unit is
not working
The unit starts
and stops frequently
Poor heating
peñormance
lndicator lamps
continue flashing
Error code appears in
the window display of
indoor :
- EO, E1, E2
- P1, P2, P3
- F1, F2, F3
40

POSSIBLE CAUSES
Power outlet failure.
The power is turned off
The fuse is burned out
Remote control batteries are dead
3 minute protection
the team has been activated.
The timer has been activated.
There's too much or too little
refrigerant in the system
lncompressible gas or moisture
has entered the system.
The compressor
is broken
The voltage is too high
or too low
The outdoor temperature is
lower than 7°C (44.5º F)
Cold air is entering through
doors and windows
Low refrigerant due to leak
or long-term use
The unit may stop operation or continue to run safely. lf the indicator lamps
continue to flash or error codes appear, wait for about 1 O minutes. The problem
may resolve itself.
lf not, disconect the power, then connect it again.
Turn the unit on.
lf the problem persists, disconnect the power and contact your nearest customer
service center.
Split 1x1
5. TORUBLESHOOTING
SOLUTION
Wait for the power to
be restored
Turn on the power
Replace the fuse
Replace batteries.
Wait 3 minutes and start
again the team.
Start the timer.
Check for leaks and recharge
the system with refrigerant.
Vacuate and recharge the
system with refrigerant
Replace the compressor
Install a manostat to
regulate the voltage
Use a device auxiliary calefactor
Make sure that all doors and
windows are closed during use
Check for leaks, re- seal if
necessary and top off refrigerant
AROMA 2E