Denver ECQ-103 Manual página 4

3.3.1 Press the M button once to set the clock hour, and then press the "+" /"-" key
repeatedly to adjust the hour. Hold down the "+" /"-" key to continuously adjust.
3.3.2 After setting the hour, press M to set the clock minute, and press "+" /"-" repeatedly to
adjust the minute. Hold down the "+" /"-" key to continuously adjust.
3.3.3 When the setting is complete, press the M button to exit.
3.4 Alarm settings:
3.4.1 Hold down the "+" or "-" key to turn the alarm clock on or off. The alarm indicator will
light up after the alarm clock is turned on.
3.4.2 After turning on the alarm clock, hold down the M button to enter the alarm hour
setting, and press the "+"/"-" key repeatedly to adjust the hour. Hold down the "+"/"-" key to
continuously adjust.
3.4.3 After setting the hour, press M once to enter the alarm minute setting, and press
"+"/"-" repeatedly to adjust the minute value. Hold down the "+"/"-" key to continuously
adjust.
3.4.4 When the setting is complete, press M to exit.
3.4.5 After the alarm bell rings, do not do anything. After the alarm bell has rung for 3
minutes, the alarm will automatically turn off, or hold down the Clock button to turn off the
alarm clock.
3.4.6 When the alarm bell rings, press any button to enter the snooze state. The alarm will
ring again after 5 minutes. After 3 minutes, the alarm clock indicator is blinking during the
snooze state. In snooze mode, press any button to snooze for an unlimited number of times
(if you want to turn off the alarm completely, press and hold the "-" key to turn off the
alarm).
3.4.7 The brightness of the clock display can be adjusted in three levels (high, low, off) : Use
the "+" and "-" buttons to adjust the brightness of the digital display, and the default setting
is the brightest. Each press of "-" reduces the brightness by one level, and each press of "+"
increases the brightness by one level. Press the button again to turn off the clock display.
3.5 Power saving function:
3.5.1 Button battery is only used for clock memory function.
3.5.2 When the external power supply is disconnected, all functions are invalid and will
return to normal when the power is restored.
4. Precautions:
Special note: If you want to use the alarm clock, wireless charger and USB output at the same time,
be sure to use the QC2.0 or QC3.0 power adapter; if you use the 5V voltage supply, the wireless
charger and alarm clock can work normally at the same time.
4.1 Do not squeeze or collide.
4.2 Do not disassemble it or put it into fire or water to avoid short circuit leakage.
4.3 Do not use the wireless charger in extremely high temperature, humidity or corrosive
environments to avoid damaging the circuit and causing leakage.
4.4 Do not place the magnetic card (ID card, bank card, etc.) with magnetic stripe or chip too close
to the unit to avoid magnetic card failure.
4.5 Please keep the distance between the implanted medical device (pacemaker, cochlear implant,
etc.) and the wireless charger > 20 cm to avoid potential interference with the medical device.
4.5 Children should be supervised to ensure that they do not play with wireless chargers as toys to
ENG - 4