Beper 70.411 Manual De Instrucciones página 8

Aroma Diffuser Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
PRODUCT SPECIFICATIONS Fig.A
01. Vent hole
02. Cover
03. Internal water tank
04. Maximum water level line (internal)
05. On/off and speed button
06. On/off LED light button
07. Low/medium/high speed indicator
08. DC jack
09. Power supply
OPERATION
IMPORTANT NOTES BEFORE USE:
Only use the product as described in this manual.
Before plugging in, ensure the voltage is correct.
The product must be placed on a flat and stable surface. Do not use the product if the power cord is damaged.
Do not use detergents, solvents or aggressive agents to clean the product.
Do not use corrosive fragrances as citrus fruits, citronella or lemon because they could cause permanent dama-
ges to the product.
Only use clean and room temperature water to fill the tank.
Always unplug the item before cleaning it.
Do not use the product outdoors.
Do not immerse the product in water or other liquids, keep it away from showers, bath or similar places.
1. Remove the external cover and the tank lid inside the product
2. Fill the tank with clean water without exceeding maximum level (100 ml)
8