Craftsman 113.177780 Manual Del Propietário página 7

Assembly (continued)
7. Insert the caster stem into the socket of
the caster foot as shown. (Front casters
only).
Caster Stem
Caster Ball
i
Socket _:_
8. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will be able to hear the
ball snap into the socket and the caster
will swivel easily when positioning is
correct.
9. Rotate drum/caddy assembly upright,
using a long phillips screwdriver, install
(8) #10 x 3/4" screws into matching
holes on both right and left side of
caddy. Tighten screws until just snug.
Do not over tighten as this may tend to
deform the caddies.
#10 x 3/4"
Screw (8)
Vac Assembly
1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum Drum
Latch Latch
Latch.
Drum