Craftsman 113.177780 Manual Del Propietário página 8

Assembly (continued)
Installing Handle
Your metal handle comes packaged in
the carton in the reverse direction. You
must pull the metal handle completely out
of Vac and reinstall the handle in the
correct direction, bent area facing away
from the back of the Vac, before
continuing.
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.
To store Wet/Dry Vac, press and hold
release buttons while firmly sliding handle
down.
Metal Handle in
Reversed Position
Removing Handle
Press and hold release buttons, as
shown. While firmly pushing in release
buttons, pull handle upwards to remove
(see illustration below).
Correct
Position
........... I"
i ........ i i_ Moving
i' ',',_/Position
i' !,
,,, ,,,
q Storage
Position
\
Installing Accessory Storage
Bag
Install accessory storage bag as shown
with extension wand holders facing unit.
Accessory Storage
Bag Snaps Bag
Straps (4)
Handle
Wand
Storage
Locations