Descargar Imprimir esta página

Grandstream DP755 Manual De Instrucciones página 20

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 6
ACESSANDO À INTERFACE WEB DO DP755
1. Ligue o DP755 e conecte-o à rede.
2. Conecte um computador na mesma rede que o DP755.
3. Acesse ao diretório "Rede" no seu computador.
4. Localize o dispositivo "DP755 - MAC" e clique duas vezes so-
bre ele para acessar à interface web.
Aviso: O DP755 suporta a função UPnP (habilitada por pa-
drão) para a descoberta automática pelo computador co-
nectado na mesma rede.
5. Coloque o ID e a senha do administrador para acessar ao
menu de configuração. (O ID de usuário padrão é "admin",
a senha de acesso aleatória pode ser encontrada na etiqu-
eta na parte inferior do dispositivo).
Aviso:
• Os usuários podem acessar ao DP755 colocando o endereço IP
no navegador através do computador conectado na mesma
rede.
• Por padrão, o DP755 está configurado para obter IP via DHCP.
Para confirmar o IP atribuído, verifique no menu "Network Sta-
tus" do handset DP720/DP722/DP730 registrado.
• Se não está disponível um servidor DHCP, os usuários podem
definir um IP fixo a partir de um handset registrado. Entre em
"Network Settings" e defina a opção "IP Settings" em "Static" e
coloque a informação do IP. (O PIN padrão do DP755 é "0000").
Consulte os documentos em linha e os FAQ para informação
mais detalhada:
http://www.grandstream.com/our-products
~35~
Common part:
This equipment complies with radiation exposure limits set forth
for an uncontrolled environment. This transmitter must not be
co-located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.
U.S. FCC Part 15 Regulatory Information
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Canada Regulatory Information
Radio equipment
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Development
Canada's licence-exempt RSS(s).
~36~

Publicidad

loading