Eazyzap DF756 Manual De Instrucciones página 4

EN
Changing the Bulb
WARNING: Always disconnect the appliance from the power supply before changing the
bulb.
1. Unscrew the collection tray [Fig. 1].
2. Lay the appliance on the side.
3. Unscrew the two screws holding the bottom plate [Fig. 2].
4. Hold the ends of the bulb and just pull to remove it from its socket.
5. Replace with a new bulb.
6. Re-locate the bottom plate and screws.
7. Screw the collection tray back into place.
1
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The The unit is not switched on
appliance is
not working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Tube has expired
Tube is faulty or has not been fitted
correctly
Technical Specifications
Note: Due to our continuing program of research and development, the specifications herein may be
subject to change without notice.
Model Voltage
DF756 220-240V~ 50-60Hz
4
DF756_ML_A5_v2_20230919.indb 4 DF756_ML_A5_v2_20230919.indb 4
Probable Cause
Dimensions
Power
h x w x d (mm)
19W 315 x 170 x 165
2
Bottom plate
Solution
Check unit plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Refer to the 'Changing the Bulb' section
Weight
1.05kg
Lamp type
PL 18W
2023/9/19 10:15 2023/9/19 10:15