Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
REMOVE PACKAGING MATERIALS
Failure to remove packaging materials could result in damage to the appliance. Remove all packing parts from
oven, racks, and heating elements. Remove protective film and labels on the outer door and control panel.
Also remove plastic on trims and panel and all tape around the oven. Open oven door and remove literature
pack and oven racks. Remove the bottom trim from the side of the oven. It will be installed at the end of the
installation process. The trim is wrapped separately in a plastic bag which will also contain the 4 screws to
secure the bottom trim and the 2 shoulder screws used to secure the product to the cabinet.
E_ PREPARING THE OPENING (FOR INDOOR USE ONLY)
NOTE: Drop-In
Ranges are designed
to hang
from the countertop
only. Do not install on a
platform
or support
rails.
Protective
Strips
(if Supplied)
Fellew instructJens packaged
with alternate
appliances.
(24" rain, dim, must be maintained
between
COoking
surface
and
underside
of appliance)
6"
Front
(If Required)
ertical
the
'
1=1/4"Min,
Ceuntertepte
top ef drawer
Allow 30" minimum
clearance
between surface units and bottom
of unprotected
wood or metal
cabinet. Allow a 24" minimum
when bottom of wood or metal is
protected
by no less than 1/4" thick
flame retardant
millboard
covered
with not less than No 28 P1SGsheet
metal (.015"), .015" thick stainless
steel, .024" aluminum
or .020"
copper.
2
Publicidad
