Publicidad
Pull-up station
MULTIFIT
ES
EN
FR
IT
DE
PT NL
SWE
PL DK
3. ASSEMBLY STEPS
Step 1.
Fit the two pieces of the foot tube (A) with the tube cover (L). Connect both foot tubes with the connecting
tube (C) and with 4 sets of screws of the combination (h) listed in the table - Screw (M8+55) + Washer (M8)
+ Nut (M8). Fit both L-handles (D) with the 2 sets of screws of the combination (k) listed in the table - Screw
(M10+55) + Washer (M10) into the foot tubes (A).
A
L
D
C
h
k
Step 2.
Connect the main tubes (B) to the foot tubes (A) with 6 sets of combination screws (j) - Screw (M10*45)
+ Washer (M10). Then connect the main tube (B) and the connecting tube (C) with 4 sets of combination
screws (h) - Screw (M8*55) + Washer (M8) + Nut (M8).
B
C
j
h
11
Publicidad
