Tyro Lyra Manual página 10

Please note: if you have a customised product, the cable connection and assembly may differ.
To avoid dangerous situations, please observe the following rules:
In case of changes, doubts about the rules or if something is unclear, please contact Tyro Remotes.
Please note: the Hydrus must always be connected to the power source behind a main fuse!
The standard cable connection is as follows:
Key
▲
▼
ON
OFF
Power supply 8 - 36 VDC / V+
Common / V-
4. Programming (an additional or repaired) transmitter to the receiver
Please note: all systems have already been programmed at the factory!
You can skip this part unless you wish to program an additional or repaired hand-held transmitter to the receiver!
If you wish to program an additional or new hand-held transmitter to the Hydrus receiver, take the following steps:
Step Description
1 Make sure that the Hydrus is correctly connected and has supply voltage.
2 Press the black programming button on the bottom of the receiver for 1 second, the status LED on the receiver will light up
red.
3 Switch on the Lyra transmitter, the LED on the receiver will now flash yellow.
4 The transmitter is now programmed to the receiver.
5 Make sure it works by pressing a button, if the status LED on the receiver flashes yellow (± 2x per second), the
programming was successful.
To delete all the transmitters from the memory of the receiver, keep the programming button pressed down for longer than 8 seconds
until the red status LED on the Hydrus switches off.
5. Changing functionality
The system has been programmed in pulse mode from the factory. The first programmed transmitter dictates the mode in which the
receiver operates. Additional transmitters programmed after the first transmitter will always operate the same way.
Step Description
1 Make sure that the Hydrus is correctly connected and has supply voltage.
2 Press the ON button on the Lyra transmitter until the transmitter turns on.
3 Keep the programming button pressed down for longer than 8 seconds until the red status LED on the Hydrus switches off.
4 Press the black programming button on the bottom of the receiver again for 1 second, the status LED on the receiver will
light up red.
5 Pulse mode: press the ▲ function key until the LED on the receiver flashes green.
Latching mode: Press the ▲ & ▼ function keys simultaneously until the LED on the receiver flashes green.
6 The transmitter is now programmed to the receiver and the receiver is now in the required mode.
7 Make sure it works by pressing a button, if the status LED on the receiver flashes yellow (± 2x per second), the
programming was successful.
Manufacturer: Tyro Remotes
Bedrijvenpark Twente 299
7602 KK, Almelo - The Netherlands
Wire number
3
2
-
-
1
green / yellow
Publisher: Tyro Remotes
Version:
Date:
Page 10 10