Celestron OMNI AZ 102 Manual De Instrucciones página 6

OMNI A Z 102 TELESCOPE
INSTALLING THE EYEPIECE
Your telescope comes with two Kellner eyepieces—a 10mm eyepiece and a 20mm eyepiece. The 20mm eyepiece offers lower
magnifi cation, while the 10mm eyepiece boosts power. Always start with the 20mm eyepiece. If viewing conditions are favorable,
you can switch to the 10mm eyepiece.
When you're ready to expand your collection, consider purchasing additional eyepieces for more viewing options. Any standard
1.25 in. telescope eyepiece will work with this telescope. Celestron offers kits with all the most popular eyepieces and fi lters
included.
To install the eyepiece:
1 1
1. Loosen the setscrew on the open end
of the star diagonal.
INSTALLING THE STARPOINTER FINDERSCOPE
The StarPointer fi nderscope is a red-dot sighting tool that mounts on top of your telescope tube. It will help you aim the
telescope precisely at targets so you can see them in the eyepiece.
To install the fi nderscope:
1 1
1. Remove the plastic tab on the
fi nderscope.
4 4
4. Secure the bracket by tightening the
setscrew on the dovetail slot.
6 | ENGLISH
2 2
2. Insert the silver barrel of the 20mm
eyepiece into the star diagonal.
2 2
2. If necessary, loosen the setscrew so
that the screw does not protrude into
the dovetail slot.
3 3
3. Tighten the setscrew to secure the
eyepiece.
3 3
3. Slide the fi nderscope bracket into the
dovetail slot on the telescope tube
near the focuser. The large window on
the fi nderscope should be facing the
front of the telescope.