Hisense D12CW Manual De Instrucciones página 13

Touch the hum (humidity) button to check the current humidity of the
immediate environment. Touch it again to set the humidity. The range for the
target humidity is 30%- 35% - 40% - 45% - 50% - 55%- 60% - 65% -70% -
75%- 80%. 3 seconds after setting this, the system will confirm the input value
and the machine will exit the settings and return to showing the current
humidity level. In drying mode, the target humidity cannot be changed. Long
press the humidity button for 5 seconds to display the current ambient
temperature.
Timer
Press the timer button to set the 0-24 hour timer function. It can be set at
intervals of 1 hour. Each time you press this button, the value increases by an
hour and the corresponding timer value is displayed on the screen. By setting
the value to "00", the timer function will be cancelled and the indicator will turn
off. After the timer is set and completed, the timer LED will be on throughout
the timer period. After the timer is over, the timer LED turns off automatically.
In the power-on state, set the time to turn off the machine; in standby mode,
set the time to turn on the machine.
Sleep
When you touch the sleep button, the button will light up and start the sleep
function. After no operation, all indicators will gradually turn dark and the wind
speed will be automatically switched from high to low. Touch any button to
reilluminate the indicator. Touch the sleep button again to exit sleep mode.
Mode
Auto mode - continuous drying mode. Press once to switch the mode from one
to another. The corresponding indicator will light up.
Auto mode:
The default target humidity is 60% when the machine is
running, and the target humidity can be adjusted.
Continuous drying mode:
humidity cannot be adjusted.
The machine continues to run, but the target
1