VALK NOMA Manual De Instrucciones página 11

WARNINGS
- Carefully read the instructions and identify each part before starting the assembly. Damage or accidents caused by not
following the assembly or maintenance instructions will be out of warranty.
- Do not use the chair until all the screws are tightened.
- It is recommended to mount the chair on a soft surface to avoid damage to the upholstery.
- This chair is designed to be used by only one person at a time.
- Do not sit on the armrests.
- Avoid exposing the chair to direct sunlight or other sources of heat.
- Every 4 months check and retighten the screws if they have loosened.
- To clean the fabric of the chair, use water and a microfiber cloth or non-abrasive sponge. You can also use a soft brush to clean
the surface, without applying pressure on the fabric.
- This chair allows you to adjust the height, tilt and depth of the seat, as well as the recline of the backrest:
A) Seat height: it is adjusted by the lever on the rear right side under the seat. The procedure for height adjustment is as follows:
1) Sit in the chair.
2) Pull the lever up with your right hand and hold it up.
3) The seat height will gently lower to the minimum.
4) Lift the weight of the seat slightly to raise the seat height.
5) When the seat is at the desired height, release the lever and the position will be fixed.
B) Seat depth: it is adjusted by the lever on the front right side under the seat. The procedure is as follows:
1) Sit in the chair.
2) Pull the lever up with your right hand and hold it up.
3) Slide the seat forward with your weight to the desired position.
4) Release the lever and the position will be fixed.
5) To return the seat to its original position, stand up from the chair, pull the lever upwards without weight and the seat will
return to its original position.
C) Backrest and seat recline and tilt: the synchronized mechanism allows synchronous adjustment of the backrest and seat with
a 2:1 ratio: the backrest reclines twice as much as the seat. Thus, when the back rests, the backrest reclines while the seat only
tilts slightly to follow the movement. It is adjusted by lever on the right rear under the seat, the same lever used to adjust the
height. The procedure is as follows:
1) Sit in the chair.
2) Pull the lever outward, with the right hand, releasing the tilting function.
3) Lean your back against the backrest and let your weight drop.
4) The position of the backrest will gently tilt.
5) When the backrest is in the desired position, push the lever inwards (left) setting the angle, it can be set in 3 different
positions.
6) To restore the initial position of the backrest, pull the lever outwards and rest your back on the backrest to unlock the
movement.
-You can adjust the hardness of the tilting function by turning the large thread on the front of the mechanism: turning to the right
will offer more resistance to tilting and to the left less.
More maintenance tips and assembly video on www.valkgaming.com or on our YouTube channel!
NOMA
INSTRUCTION GUIDE
9
ESP EN