KSIX RETRO2 Manual De Instrucciones página 2

Turn on/off the headphones
To turn on the headphones press the multifunction button
for 3 seconds, you will then hear "Power on". To turn them
off, do the same; you will then hear "Power off".
How to pair the headphones
Turn the headphones on as shown previously. When you do
so, the blue and red pairing lights will start to flash
alternatively, this means that the device is in pairing mode.
Activate the Bluetooth on your device, search for Ksix_Retro
on the available Bluetooth devices list and select it. Once the
connection has been successful you will hear "Device
connected". Once the headphones have been connected to
a device, they will pair with it automatically when turned on.
Troubleshooting: If the headphones do not turn on
automatically, it should be due to low battery. Please, charge
the headphones. If they do not pair with your device
properly, reset the headphones as instructed later in this
manual.
Usage method
Play/Pause
Previous/Next
song
Volume -/+
Answer/Hang
up calls
Reject calls
Call last number
called
Switch between
modes:
Bluetooth, Card,
FM
How to reset the headphones
To reset the headphones, disconnect them, access your
device's Bluetooth settings, tap on Ksix_Retro and then on
unpair. Turn them on again and repeat the pairing process.
Charging the headphones
The Ksix Retro 2 incorporates a Micro-USB port. Connect the
cable that is included in the package or a compatible cable
to a wall charger, powerbank or computer output.
It takes about 1,5 hours to charge the headphones up to full.
Troubleshooting: If the headphones LED indicator does not
turn on during its charge, it should be due to a power supply
issue. Please, check if the charging cable is correctly
connected to the charging case. Check both ends of the
Press the multifunction button
once.
To play the previous song, press
the volume down button for 2
seconds.
To play the next song, press the
volume up button for 2 seconds.
To decrease the volume, press
the volume down button once.
To increase the volume, press the
volume up button once.
To answer an incoming call,
press the multifunction button
once.
To hang
multifunction button once.
To reject an incoming call, press
the multifunction button three
times.
Press the multifunction button
twice.
Press the "M" button once.
up, press the