nducted using standard operating positions accepted by the F
CC with the device transmitting at its highest certified power l
evel in all tested frequency bands. Although the SAR is determi
ned at the highest certified power level, the actual SAR level of
the device while operating can be well below the maximum val
ue. This is because the device is designed to operate at multipl
e power levels so as to use only the power required to reach th
e network. In general, the closer you are to a wireless base stat
ion antenna, the lower the power output. To avoid the possibili
ty of exceeding the FCC radio frequency exposure limits, huma
n proximity to the antenna should be minimized.
For body worn operation, this model device has been tested a
nd meets the FCC RF exposure.Guidelines when used with an
accessory designated for this product or when used with an a
ccessory that Contains no metal and that positions the hands
et a minimum of 10mm from the body.
2.The maximum SAR value is 0.325W/kg when the device
used 10mm close to user.
IC STATEMENT
This device complies with Industry Canada's licence-exempt
RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
IC SAR
For body-worn operation, the device has been tested and
meets the standards RSS-102&IEEE 1528-2013 of IC RF
exposure, The maximum SAR value is 0.325W/kg when the
device used 10mm close to user.
Pour un fonctionnement porté sur le corps, l'appareil a
été testé et répond aux normes RSS-102&IEEE 1528-
66